TURBOJET MODEL 2012V

The Turbojet 2012V is a compact workhorse for residential and light commercial duct cleaning. It’s hard to believe an 18” wide cabinet that weighs just over 100 lbs. can provide 2700 CFM at 5” static pressure, a full-size 12” Inlet, 3-stage HEPA filtration, soft start and will run at 13 or 17 amps and has a 3 year warranty. This is performance that is found in units twice its size and weight. The 2012V’s legendary performance and size has been proven aboard ships, offshore drilling rigs, as well as mobile homes and 6,000 room hotels, and yet it is perfect for one-person operation out of a van, trailer or box truck. Model 2012V uses the same ESP speed control found in the Turbojets 3200B & 4200. The power inverter converts 115-volt single-phase household power to 3-phase 220-volt power. This eliminates the start-up power surge required by a single speed motor so the power of the 2012V is virtually the same as the 3200B except in a smaller, more compact size.  The 2012V has an optional Exhaust Flange Kit to exhaust air through a 12” twist lock hose outside the work area. This means it can be used as an air scrubber and place the building or room under negative pressure during remediation, or the HEPA can be removed to increase CFM or prevent it from becoming contaminated with smoke odors from a fire damage remediation job. FEATURES • Truly portable at 140 lbs. and only 19.5"w x 29"d x 55"h. • One-person operation, in and out of service vehicle and up and down stairs. • 2012V - 2 speed soft start 1.5 HP motor w/ 3 phase inverter and direct drive backward incline blower assembly. • Filtration includes 1st stage 18 x 24 x 6 washable "slide-in" filter, 2nd stage 18x24x1 permanent electrostatic filter and 3rd stage 18x24x6 certified HEPA filter, providing efficient filtration with maximum air flow even when dirty. Optional disposable 1st stage bag filter available • 12 Inch diameter inlet pulls 5 inches of w.c. static pressure, and 2700 CFM air flow (independently tested by an AMCA certified lab with all filters installed). • 12" rear, ball bearing wheels, 3 swivel non-marking casters up front. • Steel reinforced aluminum construction and powder-coated for a professional looking, non-marking finish. • Completely field tested by Air-Care, in our service operation. • Purchase includes 3-year limited warranty.     Easy one person loading into your service vehicle   Turbojet 2012V Replacement Filters   Item# 12"x18" dia. 1st stage reusable bag filter F1961a 18"x24"x7" disposable pleated 1st stage filter (optional) F1915 18"x24"x1" 2nd stage Electrostatic filter F1824 18"x24"x6" energy saver HEPA F1952 Turbojet 2012V Accessories   12” dia. Pogo Pole hose adapter CE1630 12” dia. Hose adapter plate for floor registers CE1513a 12” dia. X25’ Hose, heavy duty CE1942 12” dia. X25’ Hose, heavy duty w/twist lock couplers CE1942CP 12” Twist lock couplers, 1-male & 1-female w/ SS hose clamps CE2003 12”x8”x8" Plenum adapter  CE2298 Pellon, moisture barrier pre-filter F1682 Exhaust Flange Kit CE1434   Specifications Turbojet 2012V Size 19.5" W x 29" D x 55" H Weight 140 lbs. Power Required 115 V AC, 60Hz, 13 to17 amps Power Connection One, 3-wire inlet w/ dual 20 amp breaker Power Cord  One 12 gauge x 50 ft power cord Air Flow 3000 CFM free air/ 2700 CFM filtered Static Pressure 5.0 inches W.G. Attachment  12” Dia. twist lock coupler Exhaust Hose Optional 12” twist lock coupler Filtration 4 stages when pre-filter used Pre-Filter    Pellon moisture barrier First Stage   18" x 24" x 6" washable "slide-in" filter Second Stage   18x24x1, 94% Electrostatic Third Stage   18x24x6 certified HEPA Operating Range 25 to 125 deg. F (-4 to 50 deg. C) Construction Aluminum reinforced w/steel  Control Panel Single plug-able panel with all gauges, indicators, switches & meters Blower One backward inclined Motor & Inverter 1.5 HP 3 phase /single phase to 3 phase w/ soft start and 2 speeds Warranty 3 years Item #CE2012V   The Exhaust Flange Kit option allows you to exhaust air outside so the Turbojet can be used as an air scrubber in mediation or for more CFM, the HEPA filter can be removed and the exhaust air routed outdoors. This can also be useful to prevent the HEPA from becoming contaminated with smoke odor during a fire restoration job. Kit includes a blocking plate for one side and a 12” coupler on the other side. Item # CE1434                               The Turbojet 2012V is designed for ease of moving up and down stairs.   The Pogo Pole makes connecting the Turbo to a wall or ceiling register virtually effortless.